DIY Bunny Easter Egg Holder

Make Easter even sweeter with these homemade Easter Egg Bunny holders.

I found these darling little bunnies on What a cute way for the kids to showcase some of their dyed eggs, too!

Step 1: Get Your Supplies

What You’ll Need:

  • New wash cloth (any color you want, usually around $.50 – $2.00 each)
  • 8 inches of ¼ to 3/8 inch ribbon (complimentary or contrasting color)
  • 1 rubber band
  • 2 10mm googlie eyes
  • 1 inch white pompom
  • E-6000 glue
  • Scissors
  • A plastic Easter egg or any other decorated Easter egg. (If you use a plastic egg, fill it with an Easter treat.)

Step 2:
Lay out the wash cloth tag side up. Remove the tags.

Step 3:
At one corner, roll the corner in toward the center of the cloth, as tight as possible. Repeat with the other corner of the cloth.

Step 4:
Pick up the rolled wash cloth and fold it in half, with the two rolled edges outside of the roll


Step 5:
Fold back the two loose corners (these are the ears), toward the back of the loop


Step 6:
Use the rubber band to wrap around the newly created end. This will make the head of the bunny


Step 7:
Pull the ears so that they stand up


Step 8:
Take the 8 inch piece of ribbon, and wrap it around the rubber band (this hides the rubber band), tying it into a bow at the top of the bunny head, in front of the bunny ears.

Step 9:
Using the E-6000 glue, attach the pompom at the back of the loop, for the tail.

Step 10:
Then glue on the eyes, on the head, at the opposite end from the tail


Step 11:
Put your egg of choice in the loop behind the ears


Step 12: Done!

I’m going to hop along to figure out what colors my bunnies will be! Create your own bunny, share your pic on our facebook page and we might hook you up with 100 Swag Bucks. Now that’s something to spring for!